An Apartment Turnover Example That Gets Results

An Apartment Turnover Clean, Step by Step

A vacant apartment can look mostly clean and still fail the moment someone opens the fridge, checks the shower corners or runs a hand along a window sill. This apartment turnover walkthrough shows what a genuinely move-in-ready unit involves, the order the work should run in, and where rushed turnovers consistently fall short.

The example below is a typical one-bedroom condo turnover in Metro Vancouver, roughly 600 square feet, vacated the previous day. It is a composite of how these jobs usually run rather than one specific property, but the sequence and the timings are the real ones.

Why the Order Matters More Than the Effort

The single biggest difference between a good turnover and a slow one is sequence. Working top to bottom and wet-to-dry means nothing gets cleaned twice. Working randomly means dust from the light fixtures lands on counters you finished an hour ago.

Two rules carry most of it. Anything needing dwell time starts first, which in practice means the oven and any limescale treatment go on before anything else happens. And floors are always last, in every room, without exception.

The Turnover, Step by Step

Here is how a two-person team sequences a one-bedroom unit. Total time is about three hours, which is why a same-day turnover between a morning checkout and an afternoon check-in is tight but achievable.

Stage Work Time
1. Walk and document Photograph condition, note damage, check utilities are on 10 min
2. Start the dwell work Oven product on, limescale treatment on shower and taps, hood filter to soak 10 min
3. Empty everything Cabinets, drawers, closets, fridge, balcony, any abandoned items 15 min
4. High surfaces Light fixtures, vents, upper cabinets, door frames, cobwebs 20 min
5. Kitchen Oven finished, fridge interior, cabinets in and out, counters, backsplash, sink 45 min
6. Bathroom Shower and grout, toilet including base and behind, vanity, mirror, extractor cover 30 min
7. Bedroom and living Closet interiors, window sills and tracks, glass, switch plates, baseboards 25 min
8. Behind and under Fridge and range pulled where safe, floor and wall behind cleaned 15 min
9. Floors Vacuum including edges and corners, then mop, working toward the door 20 min
10. Final walk Floor-level check, photograph the finished unit, report any damage 10 min

Stage 2 is the one most people skip and it is the one that saves the most time. Putting oven product and limescale treatment on at the ten-minute mark means both have had well over an hour to work before anyone touches them. Scrubbing a cold dry oven at the end of a shift takes three times as long and gets a worse result.

Empty apartment hallway during a move-out turnover clean in Vancouver
Documenting the empty unit before and after is what makes a turnover defensible if condition is ever questioned.

Where Rushed Turnovers Fall Short

When a turnover gets compressed, the same things get dropped every time, and they are precisely the things an incoming tenant or guest notices in the first five minutes.

Commonly Missed Who Notices, and When
Inside the fridge, especially the under-drawer tray Day one, unpacking groceries
Range hood filter First time they cook
Shower corners and grout line First shower
Behind and under the toilet First proper look
Window tracks and sills First time a window is opened
Closet floors and shelf edges Day one, moving in
Cabinet interiors and drawer tracks Day one, unpacking
The wall behind where the bin stood Immediately, by smell

Every row on that list is an empty-unit job. None of them is reachable when a property is furnished and occupied, which is the whole argument for doing a proper turnover between tenancies rather than a standard clean.

The Documentation Step

Stages 1 and 10 are not padding. Photographing the unit empty before work starts and again when it is finished takes twenty minutes in total and settles almost every condition question that arises afterwards.

For landlords and managers this is the supporting evidence behind any deposit deduction, and our landlord cleaning inspection guide covers what makes that documentation hold up. For outgoing tenants it is proof the unit was returned properly, which is the point of our guide to what BC landlords can charge for.

Empty condo living room after an apartment turnover cleaning in Vancouver
The finished unit, photographed at the end. Floors go last in every room, working toward the door.

Short-Term Rental Turnovers Are Different

Everything above applies to a tenancy turnover, where the unit is empty and the deadline is an inspection. A short-term rental turnover is a different job: the unit is furnished, the deadline is a check-in time a few hours away, and linens are part of the scope.

The sequencing logic still holds, but the window is far tighter. A studio or one-bedroom needs about four hours between checkout and check-in once laundry, inspection and building access are counted, which is why scheduling turnovers without gaps is worth reading if you host. Our Airbnb and short-term rental cleaning runs on that basis.

What It Costs

A turnover is priced as a one-time deep clean, flat-rated by property size rather than by the hour, so a unit that takes longer than expected does not cost more:

Unit Size Turnover / Deep Clean
Up to 600 sq ft $249 + tax
Up to 1,000 sq ft $299 + tax
1,000 to 1,300 sq ft $349 + tax
1,300 to 1,500 sq ft $399 + tax
1,500 to 1,800 sq ft $449 + tax

Inside the fridge is $25 plus tax and steam carpet cleaning is $50 plus tax per bedroom, which between them cover the two most frequently disputed items on a condition report. The full model is explained in flat-rate house cleaning.

Turnover Cleaning Across Metro Vancouver

We run apartment and condo turnovers throughout the Lower Mainland, including Vancouver, Downtown Vancouver, Kitsilano, Burnaby, Richmond, New Westminster, North Vancouver and Surrey. For whole buildings, strata cleaning covers common areas alongside the suites.

If you have a tenancy ending and a date to hit, get a flat-rate turnover quote and you will know the cost before the unit is empty.

Frequently Asked Questions

How long does an apartment turnover clean take?

About three hours for a one-bedroom of roughly 600 square feet with a two-person team, including documentation at both ends. Larger units scale from there, and a unit where the oven has not been cleaned in years will run longer on that one item alone.

What order should a turnover clean be done in?

Document first, then start anything needing dwell time such as the oven and limescale treatments. Empty the unit, work high surfaces down, then kitchen, bathroom, bedrooms and living areas, then behind and under appliances, then floors last in every room, finishing with a final walk and photographs.

What gets missed in a rushed turnover?

Inside the fridge and its under-drawer tray, the range hood filter, shower corners and grout, behind and under the toilet, window tracks, closet floors, cabinet interiors and drawer tracks, and the wall behind where the bin stood. All of them are empty-unit jobs an incoming tenant notices on day one.

How much does an apartment turnover cost?

It is priced as a one-time deep clean, flat-rated by size: $249 plus tax up to 600 square feet, rising to $449 plus tax at 1,500 to 1,800 square feet. Inside the fridge is $25 plus tax and steam carpet cleaning is $50 plus tax per bedroom.

Is a turnover clean the same as a short-term rental turnover?

No. A tenancy turnover is on an empty unit against an inspection deadline. A short-term rental turnover is on a furnished unit against a check-in time a few hours away, and includes linens and restocking. The sequencing logic is the same but the window is far tighter.

Why photograph the unit before and after?

It takes about twenty minutes in total and settles almost every condition question that comes up later. For landlords it is the supporting evidence behind any deduction. For tenants it is proof the unit was returned properly.

Related Cleaning Guides

About the Author

Goldy Grewal, Founder of Speedy Sparkle Cleaning Services

Goldy Grewal founded Speedy Sparkle Cleaning Services to bring honest, flat-rate pricing to Vancouver homes and rentals. The team has completed over 1,000 cleans across Metro Vancouver, holds a 4.9 star rating from 79 plus reviews, carries $2M liability insurance, is WorkSafe BC registered, and is fully background checked.

By Published On: October 25th, 2026Categories: Cleaning TipsComments Off on An Apartment Turnover Clean, Step by Step

Share This Story, Choose Your Platform!

About the author : Goldy Grewal

Goldy Grewal is the founder of Speedy Sparkle Cleaning Services, a Vancouver-based home and commercial cleaning company. Goldy started the business to bring honest, flat-rate pricing to Vancouver homeowners after seeing too many families hit with surprise hourly bills. With 5+ years of experience and 1,000+ cleans completed across Greater Vancouver, Goldy leads a fully insured ($2M liability), WorkSafe BC registered, background-checked team.